Cat 3116 rear main seal installer

Search titles only. Search Advanced search…. New posts. Search forums. Log in. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. Cat oil leak. Thread starter jaymcb Start date Nov 8, I drove my for a short hop this morning to drop the kids to school. It was NOT there when I started it, so it happened in the last 5 miles of driving. This is the injector sleeve installer for the Caterpillar , B, and the C-7 engines.

This is a replacement for the CAT Fits most class 8 over the road trucks and trailers and some medium duty trucks Use the tapered driver side for bearing races and the flat side fo Eliminates airlocks and refills entire cooling system in seconds including heater core without the time consuming process of bleeding and purging This tool has two sets of rubber sleeves supplied with it for each expanding driver Range of 1.

Used for the internal adjustment of Spicer angle-spring and multiple-lever clutches Until now, a pry bar or other makeshift method was used and of Fits Davco Diesel filter models, Durable, stainless steel construction Precise, laser-cut angles Opens vent cap also Soft, ergonomic Hydraulic Fittings.

Hydraulic Hoses. Mud Flaps. Shop Supplies. Roll Up Door Parts. Aktas Airtech. Alfa Tools. Alliant Power. Ancra Cargo. ATD Tools. Automann USA. Baldwin Filters. Cat does not rent out a tool and I cant find any truck garage that has one. My crankshaft does not have a grove wore in it, could I just take the wear ring out and install the seal or is it made different than original?

After market does not list a seal. John White , Jun 25, You can replace the wear ring and seal as a unit if you can find a ring or a bearing race about the right size. Tap the ring in a bit and then tap the seal in a bit. You have togo in small steps. Mobiltech , Jun 25, Joined: Jan 2, Messages: 2, Location: Australia.

The seal and wear ring are made to go together and mustn't be separated. The seal is made to run on the wear ring diameter. The diameter of the crank is smaller and the seal won't seal on it.